TD-493G·40 High-Speed Automatic Edge Bander | Bands Ends Down to 40 mm

Overview

The TD-493G·40 is a fully equipped high-speed automatic edge bander that also solves the narrow-part problem: its end trimming station runs on a single narrow-edge rail and bands ends from only 40 mm wide. A conventional straight-line bander needs a certain panel length to feed through, so narrow parts and panels that need all four sides banded used to end up finished by hand. The rest of the chain is specified to high-speed machine standards, running from release agent, pre-milling and the infrared lamp through to double scraping and double polishing.

Stations and Capability

The station chain runs release agent, pre-milling, infrared lamp, fast melter with glue pot and auto draw-off, two pneumatic six-roller pressing beams with a no-clean dual-colour glue spreader between them, narrow-edge single-rail end trimming, rough and finish trimming, four high-speed tracing units, two scrapers plus a flexible scraper, after cleaning and two polishing heads. Because the four tracing units follow the profile of the edge band, notched, cut-out and slatted door contours are trimmed cleanly, and every station is called up from a single 21-inch industrial touch screen. A 15-24 m/min feed on 27.54 kW connected load makes it a self-contained high-speed banding cell.

Who It Is For

For factories with a high share of doors and small parts that need all four sides banded. It can run as the main high-speed bander on its own, or alongside a straight-line bander: that machine takes the long edges, this one takes the ends and narrow parts.

Note: the image on this page is representative of the series; the machine supplied is confirmed against your technical data sheet. Contact us for details and quotation.