T-E12DA Multi-Functional Six-Sided Drill | Drilling and Profiling in One

Overview

The T-E12DA six-sided drill is built on a one-piece frame-style steel body. It drills all six faces and cuts the front and back grooves in a single clamping, runs multiple shifts, and is simple to learn. The smallest part it handles is 35 x 70 mm, so a complete order can be produced as one job rather than split by panel size. Air-bearing holes across the infeed and outfeed tables protect the panel face while it slides, the Y-axis uses extended rails for maximum throughput, and dual clamps with an automatic side clamping device hold the part steady in travel.

Integrated Drill Packs

The bespoke integrated drill packs carry their own pressure rollers, which is how the machine reaches 90% drill-pack utilisation and a 30-45% gain in output. Minimum vertical hole distance is 60 mm, minimum horizontal hole distance is 128 mm in the vertical direction and 210 mm across the horizontal direction. Hinge boring sits inside the upper drill pack, so no separate hinge borer is needed.

Three-Position Grippers

The patented grippers change height with the task: below the table surface when loading, so panels sit on easily; above it when travelling idle, so they cannot scratch the face; level with it during machining, which holds horizontal-hole accuracy on small parts. The grippers also extract dust, and an adaptive gripper-change function reduces how often they have to be swapped.

Frame and Accuracy

The high-strength steel frame is welded as one piece rather than assembled from sections as on other brands. The welded frame then goes onto an imported gantry milling machine, which is what protects structural stability and accuracy, and it is stress relieved so the geometry holds over years of service.

Dynamic Acceleration Algorithms

Tuodiao’s own dynamic acceleration package covers adaptive speed for grooving, dynamic positioning for shaped parts, and a shortest tool-lift-path routine. Individual tool positions can be offset independently.

Software Interface

The open interface reads MPR, XML, DXF and BAN and connects directly to design and nesting software. There is no programming step on the shop floor: scan the QR code and the machine runs.

Choosing Between the Two

T-E12DA and T-E12DA2 differ in one specification only: one versus two 3.5 kW lower spindles. Panel range, drill packs, upper spindle, axis speeds and machine size are identical.

If the parts also need side profiling or side pocketing, see the T-E12DAC multi-functional six-sided drill, which adds a side milling head to the upper spindle and is otherwise configured like this machine.